KITPF8200FRDMEVM

Evaluation board featuring the PF8200 power management IC. The kit integrates all hardware needed to fully evaluate the PMIC It integrates a communication bridge based on the FRDM-KL25Z freedom board to interface with the FlexGUI software interface to fully configure and control the PF8200 PMIC.

• USB to I2C communication via the FRDM-KL25Z interface
• 2.5V to 5.5V operating input voltage range
• Up to seven high efficiency buck converters
• RTC supply and coin cell charger, watchdog timer/monitor
• Selectable hardwire default PMIC configuration or OTP/TBB operation
• Fast mode I2C communication at 400KHz (high speed operation supported by PMIC)
• Advance system monitoring/diagnostic via PMIC and/or system AMUX
• On-board I/O regulator with 1.8V/3.3V selectable output voltage
• Four linear regulators with load switch options

Contenu

Assembled and tested evaluation board and pre-programmed FRDM-KL25Z microcontroller board in an anti-static bag, 3ft USB-STD A to USB-B-mini cable, Quick start guide.